![]() ![]() Blending modeĪ Blend Mode may be applied to the cloned path, much like a layer blend only specific to the tool (see Blend Modes for more information). If aliasing is selected, the Hardness setting will be ignored. ![]() This toggle selects which mode will be used. AntialiasingĬloned regions can be rendered with an aliased (jagged) or antialiased (smoothed) edge. This toggle turns path smoothing on and off. The path of the Clone Stamp can be artificially smoothed to create more subtle changes in direction. ![]() A high spacing will allow more travel of the cursor between inputs to the point where the path may be returned as a series of individual inputs or dots. The Spacing setting in the Tool Bar determines the rate at which the tool path is sampled.Ī low spacing will yield a continuous path, with little 'space' between inputs. Hardness can be considered the strength of the antialiasing used to soften edges.īecause of this link, the Hardness setting is ignored if Antialiasing is disabled. Reducing the Hardness setting has the effect of softening the edge of the stamp, this will make cloned areas more diffuse (softer) and harder to detect. ![]() The Hardness setting in the Tool Bar determines how hard or soft the edges of the cloned area will be. The button appears between Brush size and Hardness only when a compatible pen or drawing tablet is detected, and Windows Ink has not been disabled in Settings. If Pressure Sensitivity is enabled, pressure on the hardware will be reflected in the size of the cloned region. Pressure Sensitivity This split-button toggle is used to enable/disable pressure sensitivity. The keys can also be used to change the size, and adding the Ctrl key to the square bracket keys increases the rate of change.īrush size accepts decimals in the Tool Bar value box, so a brush size of 10.25 is perfectly valid. The size of the area to be copied is set by the Brush size setting in the Tool Bar. Tool Bar Options Clone Stamp Tool options Brush size While cloning, circles are drawn to indicate the location of the source and destination. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |